Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
6400 Series
Art. 6458
4.3" hands free colour display digital videophone
Fig. 1
DESCRIPTION
Surface mount hands free videophone incorporating a 4.3" Hi-
Res full colour active matrix LCD monitor specific for "6 wire"
videokit (VK4K, VK4KX, VRVK and VK8K range). It includes 4 but-
tons: "camera recall" "open door" "service" and "privacy".
3 LED's* indicate the privacy activated , open door and activat-
ed functions.
Programmable privacy duration, melody type and number of
rings. Intercommunicating call and door call.
Adjustments: call tone volume switch (3 levels), picture hue,
contrast and brightness.
* The operation of some LED's and the functions described may require additional cabling
PUSH BUTTONS
Service push button.
Shorts the SB terminal to GROUND (open collector 24Vdc 100mA max) while the button remain pressed.
Privacy ON-OFF button.
When the system is in stand-by, the pressing of this button activates (LED switched on) or disables (LED switched off) the "privacy" service. The
service is automatically disabled when the programmed privacy time expires. When the service is enabled the videophone does not receive calls.
Door-open / intercommunicating call button.
With speech lines open to the entrance panel, press this button to open the door. If the terminal LD is properly connected
the relevant LED remains switched ON until the door is closed.
Intercommunication only works when the system is in the stand-by condition.
Switch 4 of the SW1 dip-switch selects the type of intercommunication:
OFF Intercommunication between two apartments - press the key button to call the videophone(s) in the other apartment.
A busy tone will signal that the other videophone is in conversation with the door station and so cannot be called.
ON Intercommunication between videophones in the same apartment
- press the key button one, two, three or four times to call videophone with extension address 1, 2, 3 or 4 (Set on
dip-switches 2&3 of SW1).
Any intercommunicating conversation is always interrupted by an external call (i.e. External calls take priority).
Intercommunication push button.
For an intercommunicating call, press as many times as the extension or address value to call (see SW3 Intercommunication Settings).
Answer push button.
On an incoming call, pressing this button allows the user to answer and converse with the visitor. The relevant LED will illuminate.
Switch off button.
With the system switched on (monitor on), momentary operation of the button will switch the video monitor off. The videomonitor
will also automatically switch off after a time delay if the button is not pressed. The relevant LED will switch off.
Camera recall button.
Press the button (Press once for door/gate 1, twice for 2 and so on up to a maximum of 4 entrances): the relevant LED
switches ON and the monitor switches on showing the video from the door panel. The speech is also live and the door can
be opened by pressing
Simplex button.
Pressing and holding the button for more than 3 seconds will switch the videomonitor into SIMPLEX speech mode. Press and hold
the button to speak to the caller (
pressed for 10 seconds the videomonitor will switch off. The videomonitor will revert to duplex speech when another call is made.
Art. 6458 - Installation instructions
191mm
.
LED will flash rapidly), release the button to listen (
D
E
27mm
PT3 PT2
G
PT1
SW1
H
F
VR1
Fig. 2
LEGEND
Connection terminals
A
8 Way dip switch bank
B
2 Way dip switch bank
C
Contrast adjustment trimmer
D
Hue adjustment trimmer
E
Speech volume control
F
Brightness control
G
Call tone volume switch
H
- 1 -
B
C
+V
–
1
2
V1
ON
ON
V2
1 2 3
4
5
6 7 8
1 2
DSW1
DSW2
LB
SB
LD
2A
3A
4A
5A
12M
LED will flash slowly). If the button is not
66251330 - V4.0 - 15/02/19
A
Publicité
Table des Matières
Manuels Connexes pour Videx 6400 Serie
Sommaire des Matières pour Videx 6400 Serie
- Page 1 6400 Series Art. 6458 4.3" hands free colour display digital videophone 191mm 27mm – PT3 PT2 1 2 3 6 7 8 DSW1 DSW2 Fig. 1 Fig. 2 DESCRIPTION LEGEND Surface mount hands free videophone incorporating a 4.3” Hi- Connection terminals Res full colour active matrix LCD monitor specific for “6 wire”...
-
Page 2: Controls And Adjustments
6400 Series Art. 6458 4.3" hands free colour display digital videophone LEDS CONTROLS AND ADJUSTMENTS Brightness control Privacy on LED (sliding wheel). It illuminates when the privacy service is enabled. Call tone volume control Generic use LED (3 levels). It is controlled from the terminals +DOL and –DOL. Nor- Speech volume control mally used to signal the door status (open or closed). -
Page 3: Technical Specification
6400 Series Art. 6458 4.3" hands free colour display digital videophone CONNECTION TERMINALS SIGNALS TECHNICAL SPECIFICATION Power Supply: 24Vac in or 20Vdc in 20Vdc Input/Output (As input 16÷20Vdc 0,5A – as out- Power consumption: Stand-by: 50mA Max put 20Vdc 0,5A max) Operating: 250mA Max –... -
Page 4: Wall Mounting Instructions
6400 Series 6400 Series Wall mounting instructions Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5 Fig. 6 Fig. 7 1. In order to install the videophone, it is necessary to remove the cover, which contains all the electronics, from the base: insert a 5.5mm flat screw driver into the clip then rotate clockwise until you listen a “CLICK!”. - Page 5 Serie 6400 Art. 6458 Videocitofono vivavoce digitale 4.3" a colori 191mm 27mm – PT3 PT2 1 2 3 6 7 8 DSW1 DSW2 Fig. 1 Fig. 2 DESCRIZIONE LEGENDA Videocitofono vivavoce montaggio da superficie con monitor a Morsettiera di connessione colori alta risoluzione LCD TFT da 4,3” specifico per Videokit “6 fili” Dip-switch ad 8 vie (VK4K, VK4KX, VRVK e VK8K).
-
Page 6: Controlli E Regolazioni
Serie 6400 Art. 6458 Videocitofono vivavoce digitale 4.3" a colori CONTROLLI E REGOLAZIONI Privacy ON/OFF LED PT1 Regolazione luminosità Quando il videocitofono è in stand-by segnala lo stato di attivazione (accesi) /disattivazione (spento) del servizio Regolazione volume della nota elettronica privacy. (3 livelli). -
Page 7: Specifiche Tecniche
Serie 6400 Art. 6458 Videocitofono vivavoce digitale 4.3" a colori CONNECTION TERMINALS SIGNALS SPECIFICHE TECNICHE Alimentazione: 24Vac oppure 20Vdc Ingresso/Uscita 20Vdc (come ingresso 16÷20Vdc 0,5A – Assorbimento: A riposo: 50mA come uscita 20Vdc 0,5A max) In funzione: 250mA – Riferimento di massa per il morsetto +V Temperatura di lavoro: -10 +50 °C Uscita fonia proveniente dal microfono e segnale dati... - Page 8 Serie 6400 Serie 6400 Istruzioni di installazione a parete Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5 Fig. 6 Fig. 7 1. Per installare il videocitofono è necessario aprirlo separando la base dal coperchio che ospita tutta l’elettronica dello stesso: inserire la punta di un giravite piatto da 5.5mm nella clip dopodiché...
- Page 9 Série 6400 Art. 6458 Interphone vidéo mains libres numérique 4.3" en couleurs 191mm 27mm – PT3 PT2 1 2 3 6 7 8 DSW1 DSW2 Fig. 1 Fig. 2 DESCRIPTION LÉGENDE Interphone vidéo mains libres montage en saillie avec écran en Bornes de branchement couleur LCD TFT de 4,3”...
-
Page 10: Contrôles Et Réglages
Série 6400 Art. 6458 Interphone vidéo mains libres numérique 4.3" en couleurs CONTRÔLES ET RÉGLAGES Privacy ON/OFF LED PT1 Réglage luminosité Lorsque l'interphone vidéo est en veille, il signale l'état d'activation (allumé)/désactivation (éteint) du service Réglage volume de la note électronique privacy. -
Page 11: Caractéristiques Techniques
Série 6400 Art. 6458 Interphone vidéo mains libres numérique 4.3'' en couleurs SIGNAUX SUR LES BORNES CARACTÉRISTIQUES TECHNIQUES : Alimentazion : 24Vac ou 20Vdc Entrée/Sortie 20Vdc (comme entrée 16÷20Vdc 0,5A – Absorption : Au repos : 50mA comme sortie 20Vdc 0,5A max) En fonction : 250mA –... - Page 12 Série 6400 Série 6400 Instructions d'installation murale Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5 Fig. 6 Fig. 7 1. Pour installer l’interphone vidéo il faut l’ouvrir en séparant la base du couvercle qui contient toute son électronique : introduisez la pointe d’un tournevis plat de 5,5 mm dans la clip , après tournez-le dans le sens inverse des aiguilles d’une montre jusqu’à...
- Page 13 - 13 - 66251330 - V4.0 - 15/02/19...
- Page 14 Art.8833-1 Art.8833-1 Title: Data creazione: Foglio 03/12/2015 Titolo: Data modifica: 03/12/2015 Videx Electronics S.p.A. Notes: Autore: Marco Rongoni Via del Lavoro 1, 63020 Monte Giberto (AP) Note: Cod.File: Phone: +39 0734 631669 - Fax +39 0734 631669 vk8k64h-002.dwg www.videx.it - info@videx.it - 14 - 66251330 - V4.0 - 15/02/19...
- Page 15 Art.140 Art.140 Title: Data creazione: Foglio 17/12/2015 Titolo: Data modifica: 17/12/2015 Videx Electronics S.p.A. Notes: Autore: Marco Rongoni Via del Lavoro 1, 63846 Monte Giberto (FM) Note: Cod.File: Phone: +39 0734 631669 - Fax +39 0734 631669 vrvk64h-001.dwg www.videx.it - info@videx.it - 15 - 66251330 - V4.0 - 15/02/19...
- Page 16 - 16 - 66251330 - V4.0 - 15/02/19...
- Page 17 - 17 - 66251330 - V4.0 - 15/02/19...
- Page 18 03/12/2015 15/12/2015 Marco Rongoni vk8k64h-008.dwg - 18 - 66251330 - V4.0 - 15/02/19...
-
Page 19: Smaltimento
DISPOSAL In accordance with the Legislative Decree no. 49 of 14 March 2014 “Implementation of the Directive 2012/19/EU on waste electrical and electronic equipment (WEEE)”. The crossed-out bin symbol on the equipment or on the packaging indicates that when the product reaches the end of its lifetime, it must be collected separately from mixed municipal waste. - Page 20 MANUFACTURER VIDEX ELECTRONICS S.P.A. FABBRICANTE Via del Lavoro, 1 FABRICANT 63846 Monte Giberto (FM) Italy FABRICANTE Tel (+39) 0734 631669 FABRIKANT Fax (+39) 0734 632475 www.videx.it - info@videx.it CUSTOMER SUPPORT VIDEX ELECTRONICS S.P.A. UK Customers only: SUPPORTO CLIENTI www.videx.it - technical@videx.it...