Assembly Drawing; Getting Start - SOUNDMASTER UR2040 Mode D'emploi

Assembly Drawing

Install the unit as below 3 steps:
1. Place the mounting/drill template under the cabinet with tape, so the unit will be located where you want to,
and drill four holes with diameter 1/16 inch drill bit
2. Fasten the screw as the above drawing with supplied Spacer+ mounting bracket+ long screw or mounting
bracket + short screw
3. Push the unit to the mounting bracket
Warning: To prevent damage, do not place any heating or cooking appliance beneath the unit, install the
unit as far as possible from a source of noise such as fridge, microwave oven etc.

2 Getting start

Power Up

When device connect to power and it's powered up first time, Automatic update function will start
automatically and scrolling text "UPDATE " is display on LCD, it may need few minutes depends
signal strength and device working environment , when signal was received, the right time should
be display on LCD accordingly. To terminate it, press any key during the period

When the automatic system setting had been terminate by user or update un-succeed, the date
and clock are defaulted to 01.01.2015 , 0:00

The all alarms are defaulted to 0:00

The unit is switched to clock auto-run mode

Default back light automatically set to dim from 23:00 to 05:59 unless you switch the auto dimmer
to OFF
3
UR2040 / English Manual