SOUNDMASTER UR2040 Mode D'emploi page 21


How to use AMS
Press and hold <AMS> for 2 seconds to active AMS mode.
a.
At the moment, the device will automatically scan the DAB station and store the station
b.
that had been scanned until scan up all the frequency or stored all the memory station, it
will exit automatically.

Review AMS stored station
a.
b.

When play DAB station,Press and hold <Info>,
a.
b.

Review the information of station
a)
b)
3.2 Listen the Radio FM
Press <
show as below:

How to search station
When the radio is ON, press <
1.
step
Press <
2.
Press and hold <
3.
receiving frequency up.
Press and hold <
4.
receiving frequency down.

How to store station into preset location
1.
2.
3.

Recall the presented station
1.
2.
3.

How to set up station by AMS (Automatic Memory Setup)
1.
2.
7
Press < > or <
Press <Enter> to confirm select and recall the frequency.
SCAN>>>Local scan\Auto \Manual for choosing.
Menu>>>Reset\Version\ Prune for choosing. (Version means review the software
version)
Press <Info> to review information of station.
There are Seven kinds of choices, it is respectively:
Station frequency and block number
1.
Data rate
2.
Station RSSI (Station Received Signal Strength Indicator)
3.
Signal error Rate
4.
DLS (Scrolling text)
5.
Program type
6.
Station name
7.
>key to turn device on, press <Mode> select work mode to FM, Display should be
> once to change the receiving frequency down by 1 step.
> to search the next radio station automatically by moving the
> to search the next radio station automatically by moving the
Press <MEM> once to select location of preset mode.
Press < > or <
Press and hold < Enter > to store value of station into The current location.
Press <MEM> once to select location of preset.
Press < > or <
Press <Enter> to Confirm select and recall the frequency.
Press and hold <AMS> for 2 seconds to active AMS mode.
In this mode, the radio will automatically scan the radio station and store the station that
had been scanned until scan up all the frequency or stored all the memory station, it will
exit automatically.
> to select station.
> once to change the receiving frequency up by 1
> to change location.
> to change location.
UR2040 / English Manual