Table des Matières
Publicité
AM175
Adjusting the Flat Panel Tilt
TO ADJUST THE TILT TENSION OF THE AM175, LOOSEN THE TENSION BOLTS LOCATED ON THE BOTTOM RIGHT AND
LEFT SIDE OF THE MAIN ARM ASSEMBLY. RE-TIGHTEN THESE BOLTS TO ACHIEVE YOUR DESIRED TENSION.
POUR RÉGLER LA TENSION D'INCLINAISON AM175, DESSERRER LES BOULONS DE TENSION DANS LA PARTIE INFÉ-
RIEURE DROITE ET DU CÔTÉ GAUCHE DE L'ASSEMBLAGE DE L'AXE PRINCIPAL. RESERRER CES BOULONS POUR PAR-
VENIR À LA TENSION DÉSIRÉE.
Tension
Bolt
Adjusting the Flat Panel Down
Step 1. Place one hand at the center top edge of
the flat panel.
Step 2. Place the other hand on the center
bottom edge of the flat panel.
Step 3. Using the upper hand, gently pull the
top of the flat panel away from the wall
while the lower hand gently pushes the
bottom of the flat panel towards the
wall.
Plastic Channel Cover Installation
Step 1. Place the plastic channel covers over
the mounting plate (2 side covers and 1
center cover).
Step 2. Gently push each cover into place,
covering the mounting slots of the
mounting plate.
Repeat steps 1 and 2 for the installation
of the lower plastic channel covers.
Répéter l'étape 1 et 2 pour
l'installation des couvercles en
plastique du canal inférieur.
Installation Instructions
Tension
Bolt
Adjusting the Flat Panel Up
Step 1. Place one hand at the center top edge of
the flat panel.
Step 2. Place the other hand on the center
bottom edge of the flat panel.
Step 3. Using the upper hand, gently push the
top of the flat panel towards the wall
while the lower hand gently pulls the
bottom of the flat panel away from the
wall.
Center Cover
Side Cover
(Short)
(Long)
Side Cover
(Long)
Page 13
Publicité
Table des Matières
