Table des Matières
Publicité
Attaching the Flat Panel to the Wall Plate
Two people are required for this step.
Il est requis deux personnes pour
cette étape.
Step 1. Place the universal brackets and the flat panel over and onto the upper and lower mounting bars of the AM175 and lower it
down. Do not release the flat panel until the flat panel is resting securely on the upper and lower mounting bars.
Securing and Leveling the Flat Panel
In the event that the flat panel
is tilted too far to one side, the
leveling screws will allow you
to compensate for this tilt by
simply adjusting the screws
with a screwdriver
(see illustration to the right for a
clearer view).
Au cas où l'écran plat penche
fortement d'un côté, les vis de
réglage vous permettront de
compenser ce basculement en
ajustant simplement les vis à
l'aide d'un tournevis
(voir illustration à droite pour
une vue plus claire).
Step 1. Use a screwdriver to adjust the
two (2) M6 x 30 leveling screws,
located on the top of the
mounting brackets.
Step 2. Once the flat panel is level, use a
screwdriver to tighten the two (2)
M6 x 30 locking screws, located
on the bottom of the mounting
brackets. Do not over-tighten
these screws.
Page 12
Do not release the flat panel until verifying the
connection between the universal mounting brackets
and the upper and lower mounting bars.
Éviter de relâcher l'écran plat jusqu'à
vérifiiez la connexion entre les supports de montage
tous usages et les poteaux de montage hauts et bas.
Upper
Mounting
Bar
Lower
Mounting
Bar
Flat Panel
Installation Instructions
AM175
ce que vous
Screwdriver
Leveling
Screw
(Pre-installed)
Locking
Screw
(Pre-installed)
Publicité
Table des Matières
