Ghibli & Wirbel SANIPRO 20.12 AP Utilisation Et Entretien page 19

www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
Periodic cleaning
Draining and rinsing the system
- Unhook the levers (8 Fig. 5) and remove
the head (9 Fig. 6).
- Fill the tank with about 3 litres of deminer-
alised water.
- Reassemble the head (6 Fig. 6) and lock
it in with the levers (8 Fig. 5).
- Switch on the device as indicated in the
relevant paragraph.
- To rinse the system, keep the lever (16
Fig. 11) on the nozzle pressed for about
2 minutes.
- At the end, switch off the device as indi-
cated in the relevant paragraph.
PROBLEM
The sanitiser isn't working.
The sanitiser is on but does
not dispense the sanitising
solution.
TROUBLESHOOTING
CAUSE
Switch not pressed.
Plug not inserted.
No current.
The system circuit is empty.
The tank is empty.
Pump fault.
ENGLISH - 5
SOLUTION
Press the switch to "ON".
Insert the plug into the sock-
et.
Check the power supply
line.
Press the lever and wait for
the internal machine circuit
to fill up to be available for
use with the dispensing
nozzle.
Fill the tank.
Contact an authorised ser-
vice centre.