Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Restoring Surface Gloss
Restore surface gloss by applying a very fine rubbing
compound and polishing the surface by hand or with a power
buffer. Finish with an application of a good quality automotive
wax.
Minor Repairs to Surface
Remove minor scratches and scuffs as follows. First, wet
sand the area with 600 grit wet sandpaper until the surface is
smooth. Then, restore the gloss as described under
RESTORING SURFACE GLOSS.
Special Finishes on Fittings
DO NOT USE powders, pads, or liquids that contain
abrasives. Many household cleansers, including detergents
for automatic dishwashers, are abrasive, and would damage
the plated or coated surfaces as well as the finish of the
acrylic bath.
Use only soap and water or mild liquid cleansers for fittings.
Suction Fittings
Should the fitting require cleaning, remove the screw from the
suction cover screen (Figure 10). Pull the cover off and
remove any lint or other material. When replacing the cover,
SCREW
SUCTION COVER SCREEN
Figure 10 - Suction Return Fitting
We want you to be completely satisfied with our products and service. If you have any comments or suggestions, please call
60 Shorncliffe Rd., Toronto, Ontario M8Z 5K1
Telephone: (416) 231-9030 - Fax: (416) 231-0929
SUCTION ELBOW
SUCTION WALL FITTING
1-800-MIROLIN toll free.
The company reserves the right to change models and specifications without notice.
www.mirolin.com
make sure that the screw registers. Put the screw back in
place and tighten to ensure there is no gap between the
tub wall and suction cover.
Clean and Purge
Warning! The internal piping of your whirlpool must be
cleaned regularly in order to reduce build up of dirt, scum
and the like. This must be done even if you only use the
tub for bathing or soaking and you do not use the jets.
Use the following clean and purge procedure at least
every week, if the tub is used daily, or every third use, if
the use is intermittent or occasional.
—
With the tub filled with bathing temperature
water to above the level of the jets, add 1 cup of
Electrasol Lemon Scented Gel - Advanced
Cleaning Power dishwashing detergent. To save
water, you can add the detergent to the tub after
use, before draining.
—
Run the pump and jets for 10 minutes. Drain the
tub.
—
Refill the tub with fresh warm water to a level
above the jets.
—
Run the pump and jets for 5 minutes.
—
Drain the tub.
Customer Service: (416) 231-5790
Canada, U.S.A.: 1-800 - MIROLIN (647-6546)
Fax, Canada: 1- 800 - 463 - 2236
C
US
84 092
03 Mar. 17
5
Publicité
Table des Matières
