Mirolin ONE PIECE BA5L/R Instructions D'installation Et Manuel Du Propriétaire

TM
BELAIRE ONE PIECE BA5L/R - TUB SHOWER
INSTALLATION INSTRUCTIONS AND OWNER'S MANUAL
READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTING THE INSTALLATION
PLEASE RECORD THE SERIAL NUMBER _________ OF YOUR TUB SHOWER AND SAVE THIS
Important: The Acrylic Tub Shower is carefully inspected
and packed for shipment. You should check your unit and
if there are any problems, contact your dealer before
installation.
Protect the tub shower from dirt and damage by leaving the
polyethylene protective film in place until installation and
other related construction are complete.
Follow Local Building Codes.
For whirlpool models refer to Whirlpool Owner's Manual
for additional Installation and Operating Instructions.
For Jet Air models refer to Jet Air Owner's Manual.
78"
FIGURE 1 - LAYOUT DIMENSIONS
TOOLS AND MATERIALS REQUIRED
Tools: Tape Measure, Electric Drill, Drill Bit (3/16"), Level,
Hole Saw and Caulking Gun
Materials: Mildew Resistant Silicone Bathroom Caulking,
Drywall Screws and Shims (if required).
CAUTION:
To cut plumbing fixture openings on the tub shower unit:
Use correct size hole saw based on selected fixture
"
design.
Cut from the finished side of the unit.
"
Use masking tape to mask the surrounding surface to
"
prevent scratches and other damages.
©
Copyright 2010 Mirolin Ind.
MODEL
R
MANUAL FOR FUTURE REFERENCE
The Copyright includes all content on the document.
General Installation Notes
Note: Dimensions are for framed openings. Refer to
specification sheet for specific product dimensions..
The Tub Shower is to fit into framed alcove as shown
"
in Figure 1 and Figure 2.
A 78" high and 60 1/4" wide clear opening is required
"
with the flange outside of the opening.
Rough-in dimensions are 78" x 60 1/4".
"
NOTE: Rough-in dimension of 60 1/4" for the width
shall be the maximum. if the opening is wider the
excessive gap will compromise the installation.
Framing: Inside dimension of the studded alcove are
"
to be as specified in Figure 1.
Shimming May Be Required
The unit will rest on the front edge and the two legs at
"
the rear and one leg in the centre of the bathing well.
Shims may be required to level the tub to ensure
adequate drainage.
The shower is fastened in place using dry wall
"
screws. Holes are to be drilled in by the installer
around the top periphery as shown in figures 3 and 4.
13"
Dry Wall
FIGURE 2 - SHOWING THE TOP VIEW OF THE
SHOWER IN THE ALCOVE.
HELP LINE INFO:
VISIT www.mirolin.com
FOR INFORMATION CALL:
TOLL FREE 1-800-MIROLIN.
13"
1