Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Setup
You must obtain and install the Backhoe Kit
appropriate for your traction unit. Use the instructions
provided in this section to install these kits.
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Lower the loader arms.
4.
Shut off the engine and remove the key.
2
Greasing the Backhoe
No Parts Required
Procedure
Before using the backhoe for the first time, ensure that
all of the fittings are fully greased; refer to
the Backhoe (page
6).
3
Adjusting the Seat
No Parts Required
Procedure
CAUTION
The seat mounting bracket has several pinch
points. You could pinch and/or cut your
fingers when adjusting the seat.
Take care to keep your fingers away from the
seat mounting bracket when moving the seat
up and down and when lowering the seat into
position.
1.
Shut off the engine and wait for all moving parts
to stop before leaving the operating position.
2.
Tilt the seat forward.
3.
Loosen the knobs on the bottom of the seat
(Figure
as needed.
4.
To adjust the seat height, remove the seat
adjustment bolt and nut from the seat stand
(Figure
2 Greasing
1. Knobs
5.
When you attain your desired seat height, install
and secure the bolt and nut.
6
3) to slide the seat forward or backward
3) and raise or lower the seat as desired.
Figure 3
2. Seat adjustment bolt and
nut
g348055
Publicité
Table des Matières
