Before Use; Speaker Setup - Alecto PAS-212ALED Mode D'emploi

This manual covers the PAS-212A LED, PAS-212P LED, PAS-215A LED and
PAS-215P LED.
A version stands for Active, loudspeaker with amplifier.
P version stands for Passive, loudspeaker without amplifier.
212 is 12" woofer, 215 is 15" woofer.
For operation they are the same with the above differences.
The PAS-21XA LED functions on the mains.
The PAS-21XP LED receives its signal from the PAS-21XALED or from another
amplifier connected through the supplied speaker cable with Speakon plugs.
MAINS POWER:
Use the supplied power cord to connect the PAS-21XALED with the mains. Only
connect the PAS-21XALED to a mains power of 230 Volt.
POWER SWITCH:
Use the power switch to turn the speaker on and off.
MIC VOLUME CONTROL (microphone):
You can connect a microphone using a (XLR) plug (balanced / symmetrical) or
(Jack) plug (balanced / symmetrical). You can then use the MIC volume control to
adjust the volume.
LINE VOLUME CONTROL (AUX):
You can connect separate devices to the PAS-21XALED, for example a DVD
player (sing-a-long), tablet, smartphone or separate MP3 player. These devices
are provided with a line output and can be connected to the LINE input using the
appropriate cables (not included).
- XLR input
- Cinch input
- 3.5mm stereo jack input
We recommend you to use the XLR input, Cinch input or 3.5mm stereo jack input
separately. When using multiple inputs simultaneously, the sound may become
distorted. Use the LINE volume control to adjust the volume of these inputs.
HIGH: Use this control to adjust the treble level.
LOW: Use this control to adjust the bass level.
LINE OUT: Symmetrical XLR output to an additional amplifier or active speaker.
AMP OUT: Amplifier output to connect a second passive speaker.(minimum impe
dance of the additional loudspeaker should be 8Ω.

BEFORE USE

SPEAKER SETUP

31