Alecto PAS-212ALED Mode D'emploi page 35

EXTRA LOUDSPEAKER:
It's possible to connect the PAS-21XPLED as an additional speaker to the PAS-21XA-
LED.
In any case, the signal comes from the PAS-21XALED amplifier. Use the supplied
speaker cable to connect the additional speaker according to the instructions below. The
PAS-21XPLED can be ordered as an extra speaker for the PAS-21XALED.
The PAS-21XPLED is a passive speaker and can also be connected to other separate
amplifiers.
CONNECTION OVERVIEW FOR THE ALECTO PAS-21X-set:
Power: 200Watt RMS = 400Watt music
Sensitivity: 98dB@1W/1M
Frequency Response: 45Hz-20Khz
Speakon Connection
1+ = Positive
1- = Negative
2+ and 2- = Not connected
Power: 200Watt RMS = 400Watt music
Sensitivity: 98dB@1W/1M
Frequency Response: 45Hz-20Khz
Speakon Connection
1+ = Positive
1- = Negative
2+ and 2- = Not connected
IN
LIGHT
Warning: Using the speaker for long periods of time on high volumes can
lead to permanent ear damage. To protect your hearing, please keep in mind
IN
the following:
LIGHT
• Increase
the volume starting at the minimum up to a comfortable level.
• Do not listen for long periods of time on high volumes.
• Never increase the volume to outdo or ignore environmental noise.
• Decrease the volume when you cannot hear the people around you.
OPTIONALLY AVAILABLE
PAS-212PLED
Specifications
Impedance: 8 Ω
PAS-212PLED
Specifications
Impedance: 8 Ω
OUT
OUT
MEDIA PLAYER
MODE
ON/
OFF
VOLUME MIC
MIN MAX
IN
AMP OUT
minimum 8 Ω
LIGHT
POWER
35
VOLUME LINE
HIGH
MIN MAX
MIN MAX
LOW
L/R
R
L
AUX
IN
MIN MAX
POWER CLIP
MIN MAX
VOLUME
MEDIA
MIX OUT
PLAYER
PAS-212ALED
AC 115V/230V
50/60Hz / F5A
115 230