ecofort ecoQ Sole 2000 Instructions page 51

TROUBLESHOOTING
1. Check if the power cord is plugged into an electrical outlet, if not, plug in.
2. Check if electricity to the main fuse is working
3. Check to see if the power button on the back of heater is on and lit.
E1 Error in Display: Control unit overheated. Check installation clearances.
E2 Error in Display: Tip over function. Position the heater in less than 60° working angle and restart heater.
L1,2,3,4 shows in display, but no heat: Bulb is damaged. Arrange for replacement bulb with dealer.
MAINTENANCE
Attention! Careful and regular maintenance of your heater considering our instructions assume great
importance to attain a long efficient operation of your appliance.
1. Check the reflector and IR-filament at least once a month for dust or dirt. If necessary, apply
cleaning and maintenance instructions.
2. The number of checks may be increased considering the amount of the dust in the environment.
3. Check for deformation of the reflector, wire and frame visually while cleaning the appliance. In case
of deformation, consult technical service.
4. Check the power cord and plug visually while cleaning the appliance. In case of deformation,
consult technical service.
CLEANING
Regular and careful cleaning helps your infrared heater to operate efficiently for many trouble-free years.
To clean your heater, follow the steps below:
1. Unplug the power cord for your safety before cleaning your appliance.
2. Make sure the heater is cool before continuing.
3. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a
mild detergent if necessary. After cleaning, dry the unit with a soft cloth. (CAUTION: DO NOT let
liquids enter the heater).
51