ecofort ecoQ Sole 2000 Instructions page 45

1. This heater should be installed by a competent person, i.e. a qualified electrician.
2. Always disconnected the heater from the electricity supply and allow it to cool before installation.
3. This heater can be mounted in a horizontal or vertical manner, but for a higher efficiency we recommend
horizontal usage.
4. For both wall and ceiling mounting, the lowest part of the heater must be located at or above a minimum height
of 1.8 m from ground level.
5. For both horizontal and vertical mounting on the wall, there must be a min. distance of 0.4 m between the
appliance and other walls.
6. The distance from your appliance from the corners should be min. 0.4 m for vertical use and min. 0.5 m for
horizontal use.
7. When installed to the ceiling, there must be a distance of 0.5 m between corners and the appliance.
8. The distance of your appliance from living beings must be min. 1 m.
9. The distance from the front side of the heater to materials such as wood, carton, cloth etc., must be min 1 m.
10. When mounting horizontally or to a ceiling, do not position the heater at an angle more than 90° and less than
45°.
11. The supply cable must be at the lower end of the heater if the heater is installed at an angle or vertically.
12. Keep the supply cord away from the body of the heater which will get hot during use.
13. Do not install the heater on an inflammable surface.
14. Observe the minimum safe distance between the heater body and the inflammable surfaces when mounted.
15. If the heater is to be used outside, a weatherproof outlet is recommended.
16. Before drilling ensure that there are no wires or water pipes in the area where the heater is to be installed.
17. The heater must be installed on the mounting brackets provided.
18. Fasten the brackets securely to the mounting surface and the backside of the heater using the nuts and screws
supplied.
19. Fasten the heater securely on the brackets using the nuts and bolts supplied.
20. The brackets can be used to adjust the direction of the heater, adjust the heater angle by losening the two bolts
on the wall mounting bracket, tighten the bolts again when the desired angle is reached.
45