Displays; Alarms - Dal Zotto MARTA IDRO 2.0 Manuel Utilisateur

DISPLAY
OFF
Generator o
START
The start-up phase is in progress
PELLET FEEDING
Continuous pellet feeding is in progress during the ignition phase
IGNITION
The ignition phase is in progress
START UP
The start-up phase is in progress
WORK
The normal work phase is in progress
MODULATION
The generator is working at minimum
BURN POT CLEANING
Automatic burn pot cleaning is in progress
*BURN POT CLEANING
Automatic burn pot cleaning is in progress - due to insu cient depression.
DEPRESSION
FINAL CLEANING
The nal cleaning is in progress
STAND BY
Generator o waiting for re-ignition due to an external thermostat
A new ignition is attempted when the generator has just been switched o . When the generator switches o , one must wait for
STAND BY
the complete shutdown of the fumes motor, then clean the burn pot. The generator can only be re-ignited when these operations
COOLING
have been performed.
HOFF
Generator o due to water temperature over set.
*T AMB
Displays room temperature (in the models designed for it).
*T OFF
Generator o waiting for re-ignition as all the requests have been satis ed
STAND BY
The generator is cooling after a power cut.
BLACK OUT
Once cooling is completed it will re-start automatically
The anti-freeze function is in progress as the H2O t° is below the factory set threshold
ANTI FREEZE
the pump is active until the water reaches the pre-set factory parameter +2°C
The pump antilock function is in progress (only if the generator has been in an OFF state for at least 96 hours); the pump is
ANTILOCK
activated for the time pre-set by the manufacturer, in order to prevent it from blocking
AUTO BLOW
The automatic blow is active
*EXCHANGER BLOCK
Automatic exchanger cleaning is blocked
DISPLAY
Indicates the presence of an alarm.
ASPIRATION
Fumes motor fault
FAULT
* on applicable models.
56

DISPLAYS

ALARMS

EXPLANATION
ENGLISH
REASON
On: indicates the presence of an alarm
Flashing: indicates the deactivation of the depression sensor.
The alarm can be reset by pressing key 1/
has stopped and if 15 minutes have elapsed from when the alarm was displayed.
Contact after-sales centre
SOLUTION
for 3 seconds only if the fumes motor