Tp4 Function Settings - Trotec TP4 Manuel D'utilisation

10. TP4 function settings

Various functional settings can be applied us-
ing the additional function (mode) selec-
tion button
°C/°F
functional mode each time the mode button is
MAX/MIN
pressed (see illustration).
To set the desired function, press the mode
button
on/off
H
function symbol flashes on the display.
Now set the desired value or functional status
°C/°F
H
using the up
on/off
L
During each measurement, the TP4 addition-
ally determines either the maximum tempera-
°C/°F
L
ture value (MAX) or minimum temperature
value (MIN) as selected and shows it on the functional tem-
perature display . The value set (MAX or MIN) is shown on
the status display for the additional functions
is preset in the factory to maximum temperature.
The TP4 has an individual emission factor setting and an
acoustic alarm for freely selectable upper and lower alarm limit
values. To activate or deactivate the alarm function and to set
the desired alarm limit values or the emission factor, navigate to
the corresponding function mode using the mode button
B - 07
All manuals and user guides at all-guides.com
. The TP4 switches to the next
repeatedly until the respective
or down selection buttons.
. The value
Operating manual – English
and set the desired value or function status using the up
down selection buttons.
These settings are stored in the device - even when it is
switched off - until the next setting change.
The TP4 has a continuous measurement function. In this mode,
the device measures the temperature continuously without the
measurement button having to be pressed. To activate this
function, press the mode button
sponding function symbol
continuous measurement using the up
tion button.
When continuous measurement is activated, it is not
possible to change the display status of the background
lighting or laser beam display. You should therefore select
the appropriate settings before activating continuous
measurement.
In order to determine measured values for different surfaces
during continuous measurement, you can set the emission
factor for the respective material at any time using the up
and down selection buttons without interrupting the
measurement process.
repeatedly until the corre-
flashes on the display and activate
or down selec-
or