Eschenbach mobilux LED Série Mode D'emploi page 12

1. Hold the mobiluxLED with the lens centrally over the text that is to be magnified.
2. The optimal imaging quality with mobiluxLED is to be obtained when you maintain
the distance to the lens determined for you for the magnification used by you. This
value (in mm) is to be found in the chapter "Technical data", "Spacing lens-eye"
as well as above the switch on your mobiluxLED.
3. Switch the LED light on by sliding the shifter (e) in the direction of the lens (r).
4. After use, switch the LED light off by sliding the shifter (e) in the direction
away from the lens (r).
Note: If the LED flickers, the batteries are drained and must be exchanged for new
ones. In this case, proceed as detailed in the chapter "Initial device operation".
If the colour of the light is unpleasant for you, you can place the enclosed yellow
LED filter cap (q) over the LED, as shown in the top figure on page 3.
To protect the lens your mobiluxLED is supplied with a case which, by means of a
belt loop, can be attached to your belt.
To enable you to hang your mobiluxLED around your neck it has an eyelet located
on the end of the handle and through which a lanyard, which is optionally available,
can be threaded. (Stock.-No. 15981).
mobiluxLED_multi.indd 12
12
31.03.2011 17:42:54