Install Warming Drawer Deflector Kit (Only For Ovens Installed Above Warming Drawers) - Whirlpool W11416030A Manuel Du Propriétaire

5. The bottom vent and bottom vent trim (required when the
oven is installed with the feet in the tall position) are shipped in
the foam packing at the top of the oven. To install only the
bottom vent, see the following instructions. To install both the
bottom vent and the bottom vent trim for installations with the
feet in the tall position, see the instructions in Step 6.
� Align vent tab (B) with oven frame (A) as shown.
� Using one #8-18 x
3
tab (B), fasten the vent securely to the oven.
A. Oven frame
B. Vent tab
6. On models with the feet installed in the tall position, the
bottom vent trim must also be installed. See the following
instructions to install.
� Flex the upper vent piece (C) away from the lower vent
piece (D) to slide the bottom vent trim (B) between them.
Some force may be required to flex the upper vent trim (C)
away from the lower vent trim (D). Some force may also be
required to flex the bottom vent trim (B) and slide it into
position. Make sure screw holes are properly aligned
between the two pieces. See the following illustration.
� Install the bottom vent trim (B) to the lower vent piece (D)
using two #8-18 x 1 /
A. #8-18 x
B. Bottom vent trim
C. Upper vent piece
D. Lower vent piece
16
/ " screw (D) on each side of the vent
8
C. Bottom vent
D. #8-18 x 3 / screws
8
" (6.4 mm) screw on each side.
4
1 / " (6.4 mm) screw
4
� Align vent tab (B) with oven frame (A) as shown.
� Using one #8-18 x
3
the vent tab (B), fasten the vent securely to the oven.
A. Oven frame
B. Vent tab
C. Oven vent
7. Replace the oven racks.
8. Replace the oven door. See the "Replace Oven Door(s)"
section.
9. Check that the door is free to open and close. If it is not,
repeat the removal and installation procedures. See the
"Prepare Built-In Oven" section.
10. Repeat for lower oven door.
11. Reconnect power.
12. The display panel will light briefly, and "PF" should appear in
the display.
13. If the display panel does not light, reference the Warranty.
Install Warming Drawer Deflector Kit
(Only for Ovens Installed Above
Warming Drawers)
On oven models installed above a warming drawer, a warming
drawer deflector kit must be installed. See the "Tools and Parts"
section for information on ordering.
Parts Supplied in Deflector Kit
A. Phillips-head screws (4)
only 2 screws for 27" (68.6 cm) size
B. Warming drawer deflector (1)
/ " (9.5 mm) screw (E) on each side of
8
D. Bottom vent trim
E. #8-18 x 3 / " (9.5 mm) screw
8