Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Align vent tab (B) with oven frame (A) as shown.
Using one #8-18 x ³⁄₈" screw (E) on each side of the vent
tab (B), fasten the vent securely to the oven.
E
D
A. Oven frame
B. Vent tab
C. Oven vent
8. Replace the oven racks.
9. Replace the oven door by inserting the ends of hinges into
the hinge slots in the oven frame.
10. Push the hinges in as far as they will go and open the oven
door. You should feel the oven door drop into place.
11. Rotate both hinge latches back to the locked position.
12. Check that the door is free to open and close. If it is not,
repeat the removal and installation procedures. See the
"Prepare Built-In Oven" section.
13. Repeat for lower oven door.
14. Reconnect power.
15. The display panel will light briefly, and "PF" should appear in
the display.
16. If the display panel does not light, reference the "Assistance
or Service" section of the Use and Care Guide or contact the
dealer from whom you purchased your oven.
Install Warming Drawer Deflector Kit (only
for ovens installed above warming
drawers)
On single and double oven models installed above a warming
drawer, a warming drawer deflector kit must be installed. See the
"Tools and Parts" section for ordering information.
Parts Supplied in Deflector Kit
A. Phillips head screws (4)
only 2 screws for 27" (68.6 cm) size
B. Warming drawer deflector (1)
A
B
C
D. Bottom vent trim
³⁄₈
E. #8–18 x
" screw
A
B
Install Deflector Kit
1. Align the deflector (B) with the vent (C) as shown.
2. Using two #8-18 x ¼" screws (A) on each side of the deflector
(B), fasten the deflector securely to the vent.
NOTE: On 27" (68.6 cm) models, only one #8–18 x ¼" screw
is used on each side.
A. #8–18 x
B. Warming drawer deflector
C. Vent
3. Align vent tab (B) with oven frame (A) as shown.
4. Using one #8-18 x ³⁄₈" screw (E) on each side of the vent tab
(B), fasten the vent securely to the oven.
E
D
A. Oven frame
B. Vent tab
C. Oven vent
D. Warming drawer deflector
E. #8–18 x
A
B
C
¹⁄₄
" screws
A
B
C
³⁄₈
" screw
13
Publicité
Table des Matières
