Human Touch Ascent Serie Mode D'emploi Et D'entretien page 5

take control
THE STATUS SCREEN DISPLAYS DURING YOUR MASSAGE, PROVIDING
A QUICK REFERENCE FOR THE FOLLOWING INFORMATION
This handy display not only shows the current status for each of the settings, but allows
you to configure each setting right from this screen. Use the up/down navigation buttons
to toggle through the settings; use the right/left buttons to adjust them.
Speed — The back massage speed (not
configurable when Shiatsu or Audio Sync
is selected).
Cloud TCH — The Cloud Touch intensity.
Foot SPD — The underfoot roller speed.
Width — The Tap Touch, Percussion, or Shaitsu
horizontal massage range.
3D — The back massage intensity (not
configurable during a deep tissue massage).
The amount of time remaining
in the current massage session
Illustrates the areas currently being massaged
Menu — Displays the main menu.
Auto — Displays the Auto Programs
menu. When an auto program is running,
press to toggle among the auto programs.
The active program displays at the top of
the status screen.
Cloud — Press to adjust the Cloud Touch
intensity. The selected intensity displays
in the upper left-hand corner of the
screen.
Back — Press and hold to recline or
incline the backrest.
Legs Extend — Press and hold to
extend the footrest.
NOTE: During Auto Programs,
your leg length is automatically
measured and the program adjusted
accordingly.
humantouch.com
Indicates if chair is in ZeroG position
Indicates if chair is connected to a
Bluetooth device
The massage techniques currently
in progress
Indicates if heat is on
Stop/Power/Restore — Press this button:
• To power on the remote.
• Select STOP to stop your massage
immediately.
• Select POWER OFF, then select
RESTORE to return the chair to the upright
position before exiting.
Position — Use to move the massage
rollers to the desired position during
AcuPoint detection or when enjoying
®
a Zone or Spot massage. See Using
Manual Massage Modes on page 8 for
more information.
Heat — Press to toggle the heat on
and off. When the heat is on, the heat
icon on the screen displays red.
Legs — Press and hold to raise
or lower the footrest.
ZeroG — Press and hold to automatically
®
position the chair in ZeroG mode, raising
your feet above your heart for maximum
spine relief.
Legs Retract — Press and hold
to retract the footrest.
If the chair is not in use for three minutes the
controller display automatically shuts down. Press the
Stop/Power/Restore button to resume use. The chair
resets all settings to the default position.
6 6
Choose from three Auto Programs based on your current need, or configure your own
massage using the Manual Massage screens. You can also control the Cloud Touch air
massage intensity. For an ultra-soothing massage, turn the heat on and connect your
smartphone or tablet to the chair's built-in sound system. Or select Sound Soothe, then
choose from eight relaxing nature sound tracks.
USING THE AUTO PROGRAMS
1. To select an auto program, select AUTO to display the Auto Program menu.
RECOVERY - Relieves tension in the neck and shoulders.
ENERGIZE - Soothes and STRETCHES you from head to toe.
PERFORMANCE - an intense CLOUD TOUCH massage.
2. Select the desired program. The AcuPoint
and maps your massage programs for maximum effectiveness.
3. During auto-detection, you may use the POSITION buttons to manually select your desired
shoulder height.
4. Sit back and enjoy a world-class massage!
NOTE: You cannot access the AcuPoint detection screen after the system has finished the scan.
You will need to power off, restore, and select your desired program again to re-scan your back.
7
detection screen displays as it scans your back
®