PRO-POINT 3 in. Air Polisher Mode D'emploi page 9

V1.1
INSTALL AIR COUPLER PLUG
Prepare a standard 1/4 in. NPT coupler plug (sold separately) for use
with your tool.
1. Wrap the external threads of the coupler plug with sealant tape.
1.1 Wrap tape in a clockwise direction so it will not unravel.
1.2 Do not tape all the threads. Leave several leading threads
unwrapped for easier alignment.
2. Screw the coupler plug into the tool's air inlet and tighten with a
wrench until snug.
3. Run the compressor at a low volume and check the connection for
air leaks. Do not use the tool until all air leaks are repaired or the
faulty component is replaced.
IMPORTANT! Vibration may cause failure if a quick coupler is
connected directly to the air tool. To overcome this, connect a
leader hose to the tool. A quick coupler may then be used to
connect the leader hose to the air line hose.
WARNING! To prevent serious injury from accidental operation,
do not install a female quick coupler on the tool. It contains an
air valve that will allow the air tool to retain pressure and operate
accidentally after the air supply is disconnected.
OPERATION
IMPORTANT! Do not add too much wax to the applicator pad, as
it will increase the time and effort needed to complete the task.
A saturated pad may also separate from the disc pad during use.
1. Clean the workpiece's surface to remove dust, dirt, oil or grease.
2. Place a clean foam applicator pad securely onto the disc pad.
3. Apply about two tablespoons of wax (not included) evenly on the
clean foam applicator pad. The pad will absorb some of the wax.
4. Place the polisher's pad on the workpiece. Grip the tool with both
hands, and squeeze the trigger.
4.1 The polisher's speed is controlled by adjusting the air
regulator (not included).
Visit www.princessauto.com for more information
3 in. Air Polisher 8843872
9