PRO-POINT 3 in. Air Polisher Mode D'emploi page 12

8843872
3. Avoid adding too much air tool oil as this can cause premature
power loss and eventual tool failure. A qualified technician will need
to take the tool apart and clean out the excess oil.
4. Apply a generous amount of air tool oil to the tool before storing it
for an extended period of time (overnight, weekend, etc.). Run the
tool for approximately 30 seconds to ensure the oil is evenly
distributed throughout the tool. Store it in a clean and dry location.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not
function properly or parts are missing. If unable to do so, have a
qualified technician service the tool.
PROBLEM(S)
Tool runs at normal
speed, but loses
power under load.
Tool runs slowly. Air
flows slightly from
exhaust.
Tool runs slowly. Air
flows slightly from
exhaust.
Tools will not run.
Air flows freely from
exhaust.
12
3 in. Air Polisher
POSSIBLE CAUSE(S)
Motor parts worn.
Motor parts jammed
with dirt particles.
OR
Airflow blocked by dirt.
1. Air regulator in
closed position.
2. Damage or
excessive wearing of
internal parts.
Damage or excessive
wearing of internal
parts.
SUGGESTED SOLUTION(S)
1. Have a qualified technician
service the tool.
2. Replace tool or parts.
1. Check air inlet filter for
blockage.
2. Pour air tool lubricating oil
into air inlet as per
lubrication instructions for
clearing shipping grease.
3. Operate tool in short bursts
to clear debris.
4. If tool still jammed, clean
tool and lubricate per
lubrication instructions.
1. Open the air regulator to
desired airflow.
2a. Have a qualified
technician service the
tool.
2b. Replace tool or parts.
1. Have a qualified technician
service the tool.
2. Replace tool or parts.
For technical questions call 1-800-665-8685
V1.1