Frequently Asked Questions; Disposal Information - Sodapop Logan Notice D'utilisation

Frequently asked questions

The appliance doesn't produce any bubbles or makes very few
1. It is possible that the carbonating button hasn't been pressed down far enough.
Press the carbonating button down as far as possible and hold it in this position
until the acoustic signal sounds. Only then release the button.
2. Check that the CO cylinder is positioned correctly. It may not be screwed in cor-
2
rectly.
3. The CO cylinder may be empty and must be replaced with a full cylinder.
2
4. The glass bottle was not filled to the rated fill line. Make sure that the bottles are
filled up to the rated fill line before adding bubbles.
5. Always only use very cold, fresh water. Cold water is significantly better at absor-
bing the carbon dioxide.
Carbon dioxide is leaking after a new cylinder has been inserted
The CO cylinder must be screwed anti-clockwise into the cylinder fixture by hand. Car-
2
bon dioxide will still escape:
1. If there are possible leaks between the cylinder fixture and the cylinder valve. If
necessary, screw the cylinder into the fixture more tightly.
2. If the rubber seal has shifted when screwing it in. Remove the cylinder again and
check if there is a rubber seal in the cylinder fixture. If it has shifted, simply place it
back into the correct position in the centre of the fixture and screw in the cylinder
again. If the seal is missing, do not use the CO
If this happens, contact Sodapop customer services.
The bottle overflows during the carbonation process
1. Check whether the bottle has been filled above the rated fill line. If necessary, pour
away excess water.
2. Only press the carbonating button until the acoustic signal sounds, then release
it. Do not continue to hold it down.
Carbon dioxide continues to escape after carbonation
The carbon dioxide cylinder may have a leak.
CAUTION: Risk of choking and suffocation!
cylinder under any circumstances – risk of frostbite!
Do not remove the CO
2
Leave the soda maker undisturbed. Ventilate the room well and breath in fresh air. Con-
sult a doctor if you begin to feel unwell. Leave the room, allow the carbon dioxide to
escape with an open window and allow the cylinder to come back up to room tempera-
ture before replacing it with an intact, full one.
14
cylinder under any circumstances.
2
Specifications / Service
Model LOGAN (TYPE 1083)
A = approx.
112 mm / 4.41 in
C
B = approx.
188 mm / 7.41 in
C = approx.
A B
426 mm / 16.78 in
approx. 2 kg / 4.41 lb
approx. 10 - 40 °C
DIN EN ISO 7866 that
are identical in const-
ruction:
- Thread M18x1.5
- PH250 bar
max. filling pressure
- 425 g filling weight
- π

Disposal information

The packaging is recyclable. Ask the department responsible in your local council offices
for further information about recycling.
The appliance contains valuable materials wahich can be recycled and reused.
For this reason, contact your local waste management recycling centre for correct
disposal.
INFO
We recommend that you re-
tain the original packaging
so that you can return your appliance
to an authorised customer service if it
ever needs repair.
No guarantee is provided for any da-
mage caused by transport in unsuitable
packaging.
If you have any questions or suggestions,
please use the contact form on our website
or call us.
www.sodapop.com
Contact:
Xmodus Systems GmbH
Reiherstraße 2
35708 Haiger
Germany
Service-Hotline
+49 800 4000 244 from Germany
+43 800 4000 24 from Austria
+41 800 4000 24 from Switzerland
or the Service Portal at
service@sodapop.com
15