Télécharger Imprimer la page

Hilti WSC 85 Notice D'utilisation Originale page 27

Masquer les pouces Voir aussi pour WSC 85:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 29
7.3
Check of pivoting guard
▶ Using the operating lever, fully open the pivoting guard.
➥ The pivoting guard must close quickly and completely when the guard operating lever is released.
8
Transport and storage
Transport
▶ Do not transport this product with an accessory tool installed.
▶ Make sure that the equipment is held securely throughout all transport operations.
▶ After transporting, always check all visible parts and controls for signs of damage and make sure that
they all function correctly.
Storage
▶ Always store this product with the electric supply cable unplugged from the electricity supply.
▶ Store this product in a dry place, where it cannot be accessed by children or unauthorized persons.
▶ After a long period of storage, always check all visible parts and controls for signs of damage and make
sure that they all function correctly.
9
Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
9.1
Troubleshooting table
Trouble or fault
The power tool does not de-
velop full power.
The power tool does not
work.
No suction power or reduced
suction power
10
Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11
RoHS (Restriction of Hazardous Substances)
Click on the link to go to the table of hazardous substances: qr.hilti.com/r933.
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
*314715*
Possible cause
The extension cord is too long or
its gauge is inadequate.
The voltage provided by the elec-
tric supply is too low.
The voltage provided by the elec-
tric supply is too low.
The supply cord or plug is defec-
tive.
The on / off switch is defective.
The carbon brushes are worn.
The chip ejector channel is
blocked.
314715
Action to be taken
▶ Use an extension cord of an
approved length and/or of
adequate gauge.
▶ Check the ratings on your tool's
type identification plate.
▶ Plug in another power tool or
appliance and check whether it
works.
▶ Have the tool checked by a
trained electrical specialist.
▶ Have the tool checked by a
trained electrical specialist.
▶ Have the power tool checked by
a trained electrical specialist and
the carbon brushes replaced if
necessary.
▶ Clean the chip ejector channel.
English
21

Publicité

loading