Power Fist 8887176 Mode D'emploi page 6

8887176
15. Always disconnect the power source before performing any work on or
near the motor or its connected load.
16. Protect yourself against electric shocks when working on electrical
equipment. Avoid body contact with grounded surfaces. There is an
increased chance of electrical shock if your body is grounded.
17. The fuse must be a residual current circuit-breaker with a measured
residual current of no more than 30 mA.
18. If the device is not in use, make sure that the plug is removed from the
power source.
19. Make sure that the device is switched off before plugging in the mains
cable.
20. Make sure that the device is switched off before unplugging it.
21. Disconnect the power supply before moving or transporting the device.
22. Do not install and switch on the pump if there are people or animals in
the medium, or have contact with the medium being pumped (such as
swimming pools).
WARNING! A qualified electrician should perform all wiring.
POWER CORD
1. Do not operate this tool if the power cord is frayed or damaged as an
electric shock may occur, resulting in personal injury or property
damage.
a. Inspect the tool's power cord for cracks, fraying or other faults in
the insulation or plug before each use.
b. Discontinue use if a power cord feels more than comfortably
warm while operating the tool.
c. Have the power cord replaced by a qualified service technician.
2. Keep all connections dry and off the ground to reduce the risk of
electric shock. Do not touch plug with wet hands.
3. Prevent damage to the power cord by observing the following:
a. Never use the cord to carry the tool.
b. Do not pull on the cord to disconnect the plug from an outlet.
c. Keep the power cord clear of the tool and the tool's work path
while in operation. The cord should always stay behind the tool.
d. Keep cord away from heat, oil, sharp edges or moving parts.
6
1/2 HP Stainless Steel Submersible Sump Pump
For technical questions call 1-800-665-8685
V1.0