Proper Use; Disposal Information - Siemens VS Z4 Mode D'emploi

Children must
appliance.
Cleaning and user maintenance must never
be carried out by children without super-
vision.
Plastic bags and films must be kept out of
the reach of children before disposal.
=> Risk of suffocation.

Proper use

Only connect and use the vacuum cleaner in accordance
with the specifications on the rating plate.
Never vacuum without the dust bag or dust container,
motor protection or exhaust filter.
=> This may damage the vacuum cleaner.
Always keep the vacuum cleaner away from your head
when using nozzles and tubes.
=> This could cause injury!
When vacuuming stairs, the appliance must always be
positioned below the user.
Do not use the power cord or the hose to carry or trans-
port the vacuum cleaner.
For safety reasons, if this appliance's mains power cable
becomes damaged, it must be replaced by the manufac-
turer, their after-sales service department or a similar-
lyqualified person.
If using the appliance for longer than 30 minutes, pull out
the power cord completely.
When disconnecting the appliance from the mains, pull
on the plug itself to remove it; do not pull on the power
cord.
Do not pull the power cord over sharp edges or allow it
to be-come trapped.
When the cable is being automatically rewound, ensure
that the mains plug is not thrown towards persons, body
parts, animals or objects.
=> Use the mains plug to guide the power cord.
Pull out the mains plug before carrying out any work on
the vacuum cleaner.
Do not operate the vacuum cleaner if it is damaged.
Unplug the appliance from the mains if a fault is detected.
For safety reasons, only authorised after-sales service
personnel are permitted to carry out repairs and fit
replacement parts to the vacuum cleaner.
Protect the vacuum cleaner from the weather, moisture
and sources of heat.
Do not pour flammable substances or substances
containing alcohol onto the filters (dust bag, motor
protection filter, exhaust filter, etc.).
The vacuum cleaner is not suitable for use on
construction sites.
=> Vacuuming up building rubble could damage the
appliance.
When not in use, switch off the appliance and pull out the
mains plug.
At the end of its life, the appliance should immediately be
rendered unusable, then disposed of in an appropriate
manner.
4
never play with the
!
Please note
The mains socket must be protected by at least a 16 amp
circuit breaker.
If a circuit breaker is tripped when you switch on the vac-
uum cleaner, this may be because other electrical appli-
ances which have a high current draw are connected to
the same power circuit.
To prevent the circuit breaker from tripping, select the
lowest power setting before switching the appliance on,
and increase the power only once it is running.

Disposal information

Packaging
The packaging is designed to protect the vacuum cleaner
from being damaged during transportation. It is made of
environmentally friendly materials and can therefore be
recycled. Dispose of packaging that is no longer required
at an appropriate recycling point.
Old appliance
Old appliances still contain many valuable materials.
Therefore, please take appliances that have reached the
end of their service life to your retailer or recycling cen-
tre so that they can be recycled. For current disposal
methods, please enquire at a retailer or your local coun-
cil.
Disposal of filters and dust bags
Filters and dust bags are manufactured from environ-
mentally friendly materials. Provided they do not contain
substances that are not permitted in household waste,
you can dispose of them with your normal household
waste.
Notes on the energy label
This vacuum cleaner is a general purpose vacuum
cleaner with a primary hose.
To achieve the declared energy efficiency and cleaning
performance class on carpet and hard floor, please use the
interchangeable universal nozzle.
These calculations are based on the Commission
Delegated Regulation (EU) No. 665/2013 of 3rd May
2013 supplementing Directive 2010/30/EU.
Unless otherwise stated, all the procedures referred
to in these instructions were carried out in
accordance with the EN 60312-1:2017* standard.
*As the motor service test is carried out with the dust
collector empty, the stated motor service life must be
increased by 10% for tests with the dust collector half filled.