Electrical Connection; Data Plate; Control Panel - IKEA MATTRADITION Mode D'emploi

ENGLISH

Electrical connection

WARNING: All electrical connections
must be made by an authorised installer.
Make sure that the voltage indicated on
the product plate corresponds to the
mains voltage.
This information is indicated inside the
hood, beneath the grease filter.
WARNING: If the hood is equipped
with a plug, connect the appliance to a wall
socket that complies with current
standards, located in an accessible area.
The hood comes with a special power

Data Plate

The technical specifications are indicated
on the plate on the inner side of the
appliance

Control Panel

B
cable (type H05 VV-F); if it is damaged, ask
the technical assistance service for a
replacement.
If it is not equipped with a plug (direct
connection to the mains), or if the nearest
wall socket is not in an accessible area,
install a standardised double-pole switch
that provides complete isolation from the
mains in the event of a category III
overvoltage, in accordance with the wiring
regulations.
WARNING: Do not weld the cables!
B
Motor ON/OFF button
11