Water Pressure; Operation - Saba LVS13C45GZ17S Mode D'emploi

Connect the straight connector of the inlet
hose to the water supply securely ensuring
that the washers are securely in place at both
ends of the hose�

Water Pressure

For best operating results, incoming water pressure should be
between 0�04 MPa and 1MPa� Incoming water supply for the
dishwasher is controlled by a 'pressure switch' , so if the household
water pressure is low, dishwasher fill time will increase or may not
operate�
WARNING: Please close the hydrant after using�
Connecting to the water outlet
Insert the drain hose into a drainage pipe�
Attach the drain hose to the wall using the supplied U-bend fitting�
The end of the hose should be dropped into a drainage pipe, the
height of which should be from 500mm to 1100 mm above the base
GB
of the dishwasher�
To allow for an air gap around the end of the drain hose, the diameter
of the drainage pipe should be at least 40 mm�
44
min 40 mm
If leaks are detected, immediately shut the water supply and check
the hose connections fully�
Re-tighten the connections if necessary�
If for any reason you are unable to stop the leak yourself please seek
advice from a qualified plumber�
Levelling
Place the dishwasher on an even, stable surface�
It is very important that the dishwasher is perfectly levelled in order
to avoid it to malfunction� You can level the dishwasher by adjusting
the feet at the base of the appliance�

Operation

Your dishwasher cleans by spraying a mixture of clean water and
detergent (under pressure) against the soiled surface of dishes� The
water is pumped through a rotating spray arm, drained through a
filter removing food and soiled particles and pumped back through
the spray arm�
Soiled water is pumped out and replaced with clean water at the end
of each cycle (how many times depends on the cycle being used)�
NOTE:
Hard water conditions will adversely affect washability performance
of your dishwasher�
Hard water conditions will also contribute to "Lime" (white film
substance) deposits and/or "Scaling" on the stainless steel surface
of the dishwasher tub and heater element located in the sump
underneath the removable filter screen�
GB
45