Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
1.1 Wrap tape in a clockwise direction so it will not unravel.
1.2 Do not tape all the threads. Leave several leading threads
unwrapped for easier alignment.
2.
Screw the coupler plug into the tool's air inlet and tighten with a
wrench until snug.
3.
Run the compressor at a low volume and check the connection for
air leaks. Do not use the tool until all air leaks are repaired or the
faulty component is replaced.
IMPORTANT! Vibration may cause failure if a quick coupler is
connected directly to the air tool. To overcome this, connect a
leader hose to the tool. A quick coupler may then be used to
connect the leader hose to the air line hose.
OPERATION
CAUTION! Injury Hazard! To avoid injury, always disconnect the air
supply to the tool when attaching or removing sockets or accessories.
Use only sockets and accessories rated for impact use.
1.
Disconnect the air supply.
2.
Snap the socket or accessory over the retaining ring nested in the
square drive.
3.
Connect the air supply, hold the tool securely and press the trigger
to begin the rotating action.
4.
To loosen fasteners, move the lever (Fig. 1-1) on the back of the
drive head counter-clockwise to align the
arrow to the reverse arrow (Fig. 1-2).
5.
To tighten fasteners, move the lever
clockwise and align the arrow to select
either low (Fig. 1-3), medium (Fig. 1-4),
or high torque (Fig. 1-5) settings (small,
medium or large circles).
6.
Place the socket over the fastener, grip the impact wrench firmly
with both hands and gently squeeze the trigger.
6.1 If the tool stalls while tightening, do not raise the output
pressure of the air compressor above 90 PSI. Pressure above
90 PSI will strip the workpiece and damage the tool,
Visit www.princessauto.com for more information
3/8 in. Air Impact Wrench
8843997
Fig. 1
9
Publicité
Table des Matières
