Installing The Washer - Midea MLH27N4AWWC Instructions D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

NOTE: If you must transport the washer at a later date, you must reinstall
the shipping support hardware to prevent shipping damage. Keep the
hardware in the plastic bag provided.

INSTALLING THE WASHER

1. Run some water from the cold faucet to flush the water lines and remove
particles that might clog up the inlet hose.
2. Ensure there is a rubber washer in the hoses. Reinstall the rubber washer
into the hose fitting if it has fallen out during shipment. Carefully connect
the inlet hose marked HOT to the rear "H" inlet of the water valve.
Tighten by hand;then tighten another 2/3 turn with pliers. And COLD
to the rear "C" inlet of the water valve. Tighten by hand; then tighten
another 2/3 turn with pliers.
Do not crossthread or over-tighten these connections.
3. Install the screen washers by inserting them into the free ends of the
inlet hoses with protruded side facing the faucet.
4. Connect the inlet hose ends to the HOT and COLD water faucets tightly
by hand, then tighten another 2/3 turn with pliers. Turn the water on
and check for leaks.
5. Carefully move the washer to its final location. Gently rock the washer into
position ensuring inlet hoses do not become kinked. It is important not
to damage the rubber leveling legs when moving your washer to its final
location. Damaged legs can increase washer vibration. It may be helpful to
spray window cleaner on the floor to help move your washer into its final
position.
NOTE: To reduce vibration, ensure that all four rubber leveling legs are
firmly touching the floor. Push and pull on the back right and then back
left of your washer.
11

Publicité

Table des Matières
loading

Table des Matières