UNPACKING THE WASHER
WARNING:
• Recycle or destroy the carton and plastic bags after the washer is
unpacked. Make materials inaccessible to children. Children might use
them for play. Cartons covered with rugs, bedspreads or plastic sheets
can become airtight chambers causing suffocation.
1. Cut and remove the top and bottom packaging straps.
2. While it is in the carton, carefully lay the washer on its side. DO NOT lay
the washer on its front of back.
3. Turn down the bottom flaps-remove all base packaging, including the
cardboard, styrofoam base and styrofoam tub support (inserted in
center of base).
NOTE: If you are installing a pedestal, proceed to the installation
instructions that come with the pedestal.
4. Carefully return the Washer to an upright position and remove the carton.
5. Carefully move the washer to within 4 feet (122 cm) of the final location.
6. Remove the following from the back side of the washer:
4 bolts
4 plastic spacers (including rubber grommets)
4 power cord retainers
IMPORTANT: Failure to remove the shipping bolts* can cause the washer to
become severely unbalanced.
Save all bolts for future use.
* Any damages from failure to remove the shipping bolts are not covered by the
warranty.
10