Technical Characteristics - Gorenje Tiki GT 5 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 64
Dear customer, we thank you for purchasing our product.
PLEASE READ THE INSTRUCTIONS THOROUGHLY PRIOR TO THE
INSTALLATION AND FIRST OPERATION OF THE WATER HEATER
THIS APPLIANCE IS NOT INTENDED FOR USE BY PERSONS (INCLUDING
CHILDREN)
WITH
CAPABILITIES, OR LACK OF EXPERIENCE AND KNOWLEDGE, UNLESS
THEY HAVE BEEN GIVEN SUPERVISION OR INSTRUCTION CONCERNING
USE OF THE APPLIANCE BY PERSON RESPONSIBLE FOR THEIR SAFETY.
CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY DO NOT PLAY
WITH THE APPLIANCE.
This water heater has been manufactured in compliance with the relevant
standards and tested by the relevant authorities as indicated by the Safety
Certificate and the Electromagnetic Compatibility Certificate. Its basic technical
properties are stated upon the nameplate, glued between the connection pipes.
The water heater may be connected to water and electric power supply only by a
qualified specialist. The reach in its inside due to the repair or removal of limestone
and checking and replacement of anti-corrosion protection anode may be
performed only by an authorised service workshop.
INSTALLATION
The water heater should be installed in a room protected from the onset of
freezing conditions and located as close as possible to the points of use. Given
your particular requirements there are several models of heaters to choose from:
GT 5 O are suitable for installation above the basin/sink, while
GT 5 U may be installed below the basin/sink.

TECHNICAL CHARACTERISTICS

Type
Nominal capacity
Nominal pressure
Mass / filled with water
Anticorrosion protection of the tank
Nominal power
Nominal voltage
Heating time to 75°C
Quantity of mixed water at 40°C
2)
Power consumption
1) Time required for the electrical heating element to heat the entire tank volume, at the water
supply temperature of 10°C.
2) Power consumption required for the temperature of water in the water heater to be maintained
at 65°C, at the room temperature of 20°C, determined in accordance with the DIN 44532
standard.
16
REDUCED
[ l ]
[ MPa ]
[ kg ]
[ W ]
[ V ~ ]
1)
[ min ]
[ l ]
[ kWh/24h ]
PHYSICAL,
SENSORY
GT 5 O
GT 5 U
5
0,6
7/12
Enamelled / Mg anode
2000
230
11
9
0,25
OR
MENTAL

Publicité

Table des Matières
loading

Table des Matières