Freshness Mode; Interior Lighting; Sabbath Mode; Filter Change Notification - Bosch B36FD Serie Manuel D'utilisation

en-us Alarm
Refrigerator compartment
Freezer compartment
Switching on energy-saving mode
Press .
▶
lights up.
a
Switching off energy-saving mode
Press .
▶
a The previously set temperature is displayed.
8.5 Freshness mode
In order to keep the food fresh longer, you can switch on
the freshness mode on the appliance.
The appliance automatically sets the temperatures.
Refrigerator compartment
Freezer compartment
Switching on freshness mode
Press .
▶
lights up.
a
Switching off freshness mode
Press .
▶
a The previously set temperature is displayed.
8.6 Interior lighting
You can switch the interior lighting off or set the bright-
ness.
The interior lighting is switched off
Minimum brightness
Maximum brightness
Setting the interior lighting
Press .
1.
Press .
2.
Press / (Submenu setting) until the setting display
3.
submenu shows the required setting.
Press .
4.
8.7 Sabbath mode
To ensure that you can also use the appliance on the Sab-
bath, the Sabbath mode switches off all non-essential
functions.
During Sabbath mode, the following functions are
switched off:
¡ Super cooling
¡ Super freezing
¡ Alarm
¡ Water dispensing
¡ Ice cube production and ice cube dispensing
¡ Interior lighting
¡ Audible signals
¡ Messages on the control panel
Note: The brightness of the control panel lighting is re-
duced during the Sabbath mode.
14
43 °F (6 °C)
6 °F (−14 °C)
36 °F (2 °C)
Temperature remains un-
changed
Switching on Sabbath mode
Press and hold
▶
signal sounds.
lights up.
a
Note: After approximately 80 hours, the appliance
switches to normal operation.
Switching off Sabbath mode
Press and hold for 5 seconds until an audible sig-
▶
nal sounds.
8.8 Filter change notification
Every 6 months, the filter change notification will come on.
lights up.
Note: Increased water consumption switches the filter
change notification on sooner.
Switching off the filter change notification
Replace the water filter.
1.
The bypass cap does not need to be replaced.
Press and hold
2.
goes out.
a
a The filter change status is reset.
8.9 Filter change status
If you replace the filter before the filter change notification,
reset the filter change status.
The measurement of the filter change status
is running
Resetting the filter change status
Resetting the filter change status
Press .
1.
Press .
2.
a The submenu setting display shows ⁠ .
Press (Submenu setting).
3.
a The submenu setting display shows ⁠ .
Press .
4.
9 Alarm

Alarm

Alarm
9.1 Door alarm
If the appliance door is open for a while, the door alarm
switches on.
A warning tone sounds and
Switching off the door alarm
Close the appliance door or press
▶
a The warning tone is switched off.
goes out.
a
Door alarm warning signal
You can activate or deactivate the door alarm warning sig-
nal.
Door alarm warning signal activated
for 10 seconds until an audible
for 3 seconds.
flashes.
.