Volpi PV400 Mode D'emploi page 40

•
Battery not recharged with the requested frequency
•
Components subjected to wear (such as blades) during normal operation are not covered by
warranty.
This warranty will be applied only if the buyer will fill in the WARRANTY CARD in all requested blanks
indicating the Serial number, the purchase date (corresponding to the sale document) and the mark of
the dealer. The dealer will have to hold the warranty card and the buyer will have to hold a copy of it
and a copy of the sale document. In case of warranty claims the buyer will have to give these
documents to the dealer together with the machine. If these documents are missing the machine will
be considered out of warranty.
21. Trouble shooting and repair
Have your power tool serviced by a qualified repair person using only identical parts for replacement.
This will ensure the safety of the power tool.
Issue
Pruners doesn't work
Blade becomes hot
Bad cutting surface
Can't charging, red LED
flash
40
Possible cause
Incorrect connection
Switch fail
Blunt blade
Damaged blade
Insufficient lubrication
Friction force added
Blade is dirty
Blunt blade
Incorrect usage of the
pruner
Battery charge is low
Battery not correctly insert
in the charger
Charger not correctly
connected to power
Battery poles are dirty
Battery failure
Charger fail
Solution
Check correct
connection with the tool
and the battery.
Check the switch to be in
ON position.
Send shear to service
center for repairing
Sharp or replace blade
Sharp or replace blade
Lubricate the blade
Lubricate the blade
Clean blade
Sharp or replace blade
Read instruction carefully
Charge the battery
Re-insert the battery to
charger
Re-connect the charger
Clean the poles
Replace battery
Replace charger
wire