Volpi PV400 Mode D'emploi page 27

•
The blades have to be checked for wear in regular intervals and reshape ended. Blunt blades will
overload the machine. Resulting damages are notcovered by warranty.
•
Do not attempt to repair the tool your-self, bring the tool to our Service Center in case of need. All
works, which are not described in this manual, may only beperformed by our Service-Centre
4.3 Special safety instruction for battery tool
•
Make sure the battery switch is in "OFF" position before insert battery. The equipment can be
damaged if insertingthe battery at switch on.
•
Charger design for use only indoor. Charging operations have to be performed indoor.
•
Disconnect power before to clean the charger to avoid damage and risk of electrical shock.
•
Don't expose battery in strong light. Don't put battery on hot surface. It can cause battery
explosion.
•
Fully cold battery before charging.
•
Don't disassemble the battery, don't damage battery, in order to avoid injury.
4.4 Use charger correctly
•
Charger only use on rechargeable battery. If not it can cause fire or explode. Use original charger to
keep safety.
•
Always check charger, wire and plug before use. If damaged, please move to Customer Assistance
Service to repair. Don't use damaged charger, don't repair by yourself, this will keep the tool safe.
•
Check voltage of charger match the battery value, if not may injury yourself.
•
Disconnect the charger before switch on/off tool with connected battery and equipment.
•
Keep charger clean, away from drippy or rain environment. Don't use the charger outdoor, dirt or
water can cause injury.
•
The charger is designed for original battery only. Otherwise may be cause damage or fire.
•
Avoid damaged charger will reduce injury.
•
Don't use chargers on tinder surface (e.g. paper or dry goods).
•
The battery is not fully charged when you buy it, you must charge 4-5hours before first use the tool.
Connect the battery to charger before power on.
•
Normal charging time is 4-5hours, don't charge the battery for too long time, it will damage the
battery. Make sure charging at indicate just 1 LED light, this will ensure at battery life.
4.5 Caution (residual risk)
Keep use the tool carefully avoid risk as below:
•
Cutting or injuries due to sharp edges
•
Long times operate or irrationally use the tool will damage your body.
Warning!
The equipment will bring electromagnetism; it can interfere with some medical device in body. It is
suggestedto ask for doctor before the usage of the tool by at the same time with medical devices.
27