Hansgrohe AXOR Starck 10004 Serie Mode D'emploi page 6

Assembly
Important! The fitting must be installed, flushed
and tested after the valid norms.
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slip the fixation piece including the washer over
the threaded pin and tighten the nut.
4. Connect the supply pipes to the angle valves;
cold right - hot left.
5. Connect the pull rod to the pop-up waste.
Large differences in pressure between the hot and
cold water supply must be balanced.
Technical Data
This mixer series-produced with waterdim-
mer (flow limiter).
®
Rate of flow with waterdimmer:
Rate of flow without waterdimmer: 14 l/min 0.3 MPa
Operating pressure:
Recommended operating pressure: 0.1 - 0.5 MPa
Test pressure:
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Operation
open

English
7 l/min 0.3 MPa
max. 1 MPa
1.6 MPa
max. 80° C
65° C
close
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled con-
tinuous flow heaters if the flow pressure is at least
0.15 MPa.
If the continuous flow heater makes any problems
or there comes not enough water, the waterdimmer
(flow limiter 5a) located behind the mousseur must
be removed.
Spare parts (see page 3)
1� flange
2� handle Starck
3� handle Starck Puro
4� cartridge
5� mousseur cpl.
6� pull rod
7� fixation cpl.
8� lever arm cpl. 290 mm
Special accessories
X special tool set
(not part of delivery)
XXX = Colors
000 chrome plated
810 satinox
cold
96427X X X
10090XXX
10092XXX
96339000
94005XXX
94006XXX
96016000
96307000
58085000
hot