Sauder SmartCenter Secretary Instructions D'assemblage page 27

Step 22
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the diagram.
If it isn't, loosen the mounting screw to slide it against the
stops. Then tighten the mounting screw.
Fasten a DOOR (N) to the RIGHT END (A). Use the screws in
å
the HINGES. See the next step for door adjustments.
Fasten a KNOB (SS) and BACKPLATE (TT) to the DOOR (N).
å
Use a BLACK 1-1/8" MACHINE SCREW (FFF).
Repeat this step for the other DOOR (N).
å
www.sauder.com/services
A
N
413092
Stop
Mounting
screw
Hinge
FFF
BLACK 1-1/8" MACHINE SCREW
(2 used for the KNOBS and BACKPLATES)
SS TT
+
Page 27