Sauder SmartCenter Secretary Instructions D'assemblage page 10

Step 5
NOTE: You have the option of fastening the EXTENSION
å
BLOCKS into the hole locations of your choice in the ENDS.
This will determine the height of your PRINTER SHELF. Be
sure to use the same set of holes on each END.
Fasten the EXTENSION BLOCKS (AA) to the ENDS (A and B).
å
Use four BROWN 1-1/2" FLAT HEAD SCREWS (DDD).
Fasten the CABINET RAILS (40AW and 40AX) to the
å
EXTENSION BLOCKS (AA) on the ENDS (A and B). Use four
GOLD 5/16" FLAT HEAD SCREWS (NNN).
NOTE: The CABINET RAILS are marked "CABINET RIGHT"
å
and "CABINET LEFT" for easy identifi cation.
Before fastening the EXTENSION BLOCKS,
determine the positioning of your PRINTER SHELF.
Roller end
Short fi nished
edge
BROWN 1-1/2" FLAT HEAD SCREW
(4 used for the EXTENSION BLOCKS)
Page 10
B
DDD
A
AA
Finished surface
413092
NNN
GOLD 5/16" FLAT HEAD SCREW
(4 used for the CABINET RAILS)
Roller end
AA
www.sauder.com/services
Short fi nished
edge