Sauder SmartCenter Secretary Instructions D'assemblage page 21

Step 16
Fasten the DRAWER SIDES (V) to the DRAWER BACK (U)
å
and DRAWER BOTTOM (W). Use eight BROWN 1-1/2"
FLAT HEAD SCREWS (DDD).
NOTE: Be sure the smaller holes in the DRAWER SIDES
å
face towards the front.
V
The smaller holes
should be here.
www.sauder.com/services
Finished edge
The small center hole on the bottom
of the DRAWER BOTTOM (W) must
be closer to this front edge.
Finished surface
U
W
413092
DDD
BROWN 1-1/2" FLAT HEAD SCREW
(8 used in this step)
V
The smaller holes
should be here.
Finished edge
Page 21