Sauder SmartCenter Secretary Instructions D'assemblage page 20

Step 15
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (M) and lay it over your unit.
Make equal margins along both side edges and bottom edge of the
å
BACK (M). Push on opposite corners of your unit if needed to make
it "square".
Fasten the top edge of the BACK (M) to the VALANCE (R). Use six
å
BLACK 9/16" LARGE HEAD SCREWS (JJJ).
Finish fastening the BACK (M) to your unit using the NAILS (OOO).
å
NOTE: Be sure to tap NAILS into the holes that line up over the
å
SHELVES (H, I, and J) and UPRIGHTS (C and D).
NOTE: Perforations have been provided for access through the
å
BACK. Carefully cut out the holes needed.
JJJ
These perforations
must be here.
Page 20
R
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
These holes must line up over
the SHELVES and UPRIGHTS.
M
413092
OOO
NAIL
(62 used in this step)
BLACK 9/16" LARGE HEAD SCREW
(6 used for the top edge)
www.sauder.com/services
JJJ