Publicité
Les langues disponibles
Les langues disponibles
GB
• Avoid
working
temperatures.
• When it is cold, make sure
your body and your hands, in
particular, are kept warm.
• Take regular breaks and move
your hands at the same time to
promote circulation.
Electrical safety
• The device may only be
connected to a socket that is
correctly installed and grounded.
• The fuse must be a residual
current circuitbreaker with a
measured residual current of no
more than 30 mA.
• Make sure that the power
supply corresponds with the
connection specifications of the
device before it is connected.
• The tool may only be used
within the specified limitations
for voltage and power (see type
plate).
• Do not touch the mains plug
with wet hands! Always pull out
the mains plug at the plug and
not by the cable.
• Do not bend, crush, pull or drive
over the power cable, protect
from sharp edges, oil and heat.
• Do not lift the device using
the cable or use the cable for
at
low
• Check the plug and cable before
• If the power cable is damaged
• If the device is not in use make
• Make sure that the device is
• Make sure that the device is
• Disconnect the power supply
Maintenance
• Before
• Only those maintenance and
• Only use original replacement
18
purposes other than intended.
each use.
immediately disconnect the
plug. Never use the device if the
power cable is damaged. Only
customer service or qualified
person may change the cable.
sure the plug is pulled out.
switched off before plugging in
the mains cable.
switched off before unplugging it.
before transporting the device.
conducting
maintenance on the device,
disconnect the mains plug.
fault elimination tasks described
here may be carried out. Any
other tasks must be completed
by a specialist.
parts. Only these replacement
parts
are
suitable for the device. Other
replacement parts will not
only lead to an invalidation
any
designed
and
Publicité
