Sauder Credenza 415373 Mode D'emploi page 8

Step 2
Separate the EXTENSION SLIDES (GG) from the
å
EXTENSION RAILS (FF) as shown in the diagram below.
Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (FF) to the UPRIGHTS (C
å
and D). Use four GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the
å
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to fi nd the other hole
that lines up with the hole in the UPRIGHT. Turn a SCREW
into this hole.
Open end
Notched edge
Page 8
GG
Push the release lever in and pull the SLIDE from the RAIL.
GOLD 5/16" FLAT HEAD SCREW
FF
D
FF
3S
(4 used in this step)
FF
415373
Remember:
Righty tighty.
Lefty loosey.
Open end
Notched edge
C
www.sauder.com/services