Sauder Credenza 415373 Mode D'emploi page 31

Step 25
To insert the center drawer into your unit, line up the EXTENSION SLIDES on the drawer with the EXTENSION RAILS on
å
the unit and push the drawer into the unit until the drawer is fully inserted. The drawer will push in hard until it is all the way
in, then it will slide in and out easier.
To insert the small drawers into your unit, tip the front of the drawers down and drop the rollers on the drawers behind the
å
rollers on the unit. Lift the front of the drawers up and slide them into the unit.
Push the RUBBER SLEEVES (2R) over the METAL PINS (1R). Insert the METAL PINS into the hole locations of your choice
å
in the ENDS (A and B) and UPRIGHTS (C and D). Set the ADJUSTABLE SHELVES (O and P) onto the METAL PINS.
Apply the WARNING LABEL (3L) to the TOP (E2). You should be able to read the label when the TV is removed from the
å
unit. When the TV is in place, it should hide the label. Peel off the backing and apply the label as shown in the diagram.
NOTE: This is a permanent label intended to last for the life of the product. Once applied, do not try to remove it.
å
We recommend using the LARGE METAL BRACKET (1G) for added stability. Use a BLACK 9/16" LARGE HEAD
å
SCREW (1S) into the top of the unit and a BLACK 1-7/8" FLAT HEAD SCREW (2S) into a stud in your wall.
10 lbs.
P
S
25 lbs.
B
WARNING
Never use this furniture with a TV that is too
large or too heavy. Severe injury or death can
occur. The TV and furniture will be unstable
and may tip.
- The TV must weigh less than 95 lbs.
- The base of the TV must be able to sit
completely on this shelf.
www.sauder.com/services
E2
95 lbs.
T
20 lbs.
D
O
30 lbs.
70 lbs. total
1R
(12 used)
BLACK 1-7/8" FLAT HEAD SCREW
(1 used into a stud in your wall)
1G
BLACK 9/16" LARGE HEAD SCREW
(1 used into the top of your unit)
3L
10 lbs.
R
25 lbs.
P
C
2R
415373
2S
1S
A
Page 31