Sauder Credenza 415373 Mode D'emploi page 19

Step 13
Carefully stand your unit upright.
å
Slip a LARGE RUBBER SLEEVE (58G) over the TIE PLATE (3G). The
å
RUBBER SLEEVE will be a tight fi t.
Fasten the TIE PLATE (3G) to the hole in the MOLDING (AA). Use a
å
BLACK 9/16" LARGE HEAD SCREW (1S).
Fasten two LARGE METAL BRACKETS (1G) to the ENDS (A and B) and
å
two METAL BRACKETS (4G) to the UPRIGHTS (C and D). Use four
BLACK 9/16" LARGE HEAD SCREWS (1S).
NOTE: Be sure the BRACKETS are even with the edges of the ENDS (A
å
and B) and UPRIGHTS (C and D).
Fasten the MOLDING (AA) to the ENDS (A and B) and UPRIGHTS (C
å
and D). Use four BLACK 9/16" LARGE HEAD SCREWS (1S) through the
METAL BRACKETS and into the MOLDING.
3G
58G
1G
www.sauder.com/services
D
B
AA
F
The TIE PLATE should point
down towards the BOTTOM (F).
4G
415373
Pro Tip: Lift with your
legs. And, you know,
your arms.
BLACK 9/16" LARGE HEAD SCREW
(9 used in this step)
A
C
AA
1S
1G
4G
Page 19