Sauder Credenza 415373 Mode D'emploi page 23

Step 17
Insert the DOOR STOPS (4I) into the holes in
å
the UPRIGHTS (C and D).
Before fastening the DOORS to your unit, be sure
å
the mounting screw is against the stops as shown
in the right diagram. If it isn't, loosen the mounting
screw to slide it against the stops. Then tighten the
mounting screw.
Fasten the RIGHT DOORS (J and L) to the RIGHT
å
END (A) and RIGHT UPRIGHT (C). Use the screws
in the HINGES. You should start each SCREW a few
turns before completely tightening any of them.
Fasten a KNOB SET (99K) to each DOOR (J and L).
å
Use two SILVER 1-1/4" MACHINE SCREWS (35S).
Repeat this step for the other doors.
å
See the next step for DOOR adjustments.
å
www.sauder.com/services
D
4I
Stop
13H
Mounting
screw
Hinge
C
SILVER 1-1/4" MACHINE SCREW
(4 used for the KNOB SETS)
415373
Stop
40H
Mounting
screw
Hinge
A
J
L
35S
4I
99K
Page 23