Brine Tanks; Central Brine System; Valve Modifications For Central Brining Operation - Kinetico PRO CP 208s OD Guide D'utilisation

Brine Tanks

Required with a standard system is a brine make-up tank. These tanks will accommodate loading of
softener grade salt and provide water to dissolve brine into a saturated liquid form.
Softened water is delivered to the brine tank by the control valve during the normal regeneration
sequence.
Brine tanks include an overflow connection to allow for a safety in case of tank overflow.

Central Brine System

For larger, multiple systems, a Central Brining System alternative is
available. This will replace the need for multiple brine tanks when installing
multiple units in parallel.
The Central Brining System has features similar to the independent brine
tanks; however, to accommodate multiple systems, the brine refill is
accomplished by a float mechanism attached to the softened water supply
outlet of the system.
A check valve must be added to each softener on the brine line for the unit
to operate properly with the Central Brining System.
4724A ....................C/B Brine Drum, 24x48, Drilled
4726A ....................C/B Brine Drum, 39x60, Drilled
4728A ....................C/B Brine Drum, 50x60, Drilled
4781 ........................C/B Brine System Internals
7952 .......................C/B Brine Check Valve Kit

Valve Modifications for Central Brining Operation

Depending on the CP unit selected, the Venturi Throat may need to be changed. This will regulate the amount of salt
used per regeneration.
Unit
CP 208
CP 210
CP 213
CP 216
Also included with the brine tank is the brine valve. The brine valve is used to adjust
the volume or brine to be produced for each cycle.
No Modification
Throat Salt per Cycle
Tan (3343)
White (1043)
Yellow (6017)
Yellow (6017)
Recommended Valve Change
Throat
8.5 lb Dark Blue (2293)
30 lb Tan (3343)
42 lb Clear (2379)
42 lb Black (1045)
17
Salt per Cycle
5.5 lb
1.5 lb
19 lb
35 lb