Leica GEOVID PRO Mode D'emploi page 16

OPERATION
SETTING THE INTEROCULAR DISTANCE
SETTING THE IMAGE SHARPNESS
▸
Look through the binoculars
▸
Aim at the target object
▸
Adjust the focusing wheel until you can see the
target object with optimum sharpness
DISTANCE MEASUREMENT MADE EASY
▸
Press the main switch briefl y
▸
Aim the target mark at the object
▸
Press the main switch again
• The target mark disappears briefl y and the
measured value is displayed.
• You can do another measurement at any time by
pressing the main button while the target mark
remains lit.
will appear in the following scenarios:
- - -
– Distance to the object is less than 10 meters
– Range capability is exceeded
– Object is not suffi ciently refl ective
SCAN MODE (OBJECT TRACKING)
▸
Press the main switch briefl y
▸
Aim at the object while target mark is lit
▸
Press and hold main switch for approx. 2.5 seconds
• The device switches to scan mode and will then
ATTACHING THE PROTECTIVE LENS CAP
9 8
Note
• When positioned correctly, the protective lens cap
will fl ip open downwards.
6 1
7 2
measure continuously. Scan mode is indicated
by a change in the display. A new measured
value appears after approx. 0.5 seconds.
6 3