Publicité
Les langues disponibles
Les langues disponibles
PROBLEM
POSSIBLE CAUSE
Water is
The glass was not held
leaking or
under the dispenser long
dripping from
enough.
the dispenser
system
The water filter was
NOTE: A
recently installed or
few drops of
replaced.
water after
dispensing is
normal.
The water
Water has not been
from the
dispensed recently
dispenser
(approx. 4 days).
tastes bad
The water filter needs to
be replaced.
Water from
The refrigerator has just
the dispenser
been installed.
is warm
The refrigerator is not
connected to a cold water
pipe.
A large amount of water
was recently dispensed.
Water has not been
recently dispensed.
Water is
The water line connections
leaking
were not fully tightened.
from the
back of the
refrigerator
Water is
The refrigerator is
leaking from
automatically defrosting
the pan under
more frequently.
the freezer
drawer
The doors or drawers are
not closed completely
allowing warm air to enter.
SOLUTION
Hold the glass under the
dispenser 2 to 3 seconds
after releasing the
dispenser pad.
Flushing the water system
removes the air from the
lines which causes the
water dispenser to drip.
Flush the water system.
See "Flush the Water
System."
Dispense and discard at
least 1 gallon of water.
Replace the water filter
when indicated.
Allow 24 hours after
installation for the water
supply to cool completely.
Make sure the refrigerator
is connected to a cold
water pipe.
Allow 3 hours for the water
supply to cool completely.
The first glass of water
may not be cool. Discard
the first glass of water
dispensed.
See "Connect to Water."
Empty the drip pan. Make
sure the refrigerator is
not overcrowded and that
stored food with a high
liquid content, such as
soups, are tightly sealed.
Make sure all doors
and drawers are closed
completely.
Publicité
