Publicité
Les langues disponibles
Les langues disponibles
ICE AND WATER
PROBLEM
POSSIBLE CAUSE
The ice
The refrigerator is not
maker is not
connected to a water
producing
supply or the water supply
ice or is not
shuto valve is not turned
producing
on.
enough ice
The ice maker(s) are
turned o .
The refrigerator has just
been installed.
The ice storage bin is not
in place.
A large amount of ice was
recently removed.
An ice cube is jammed in
the ice maker ejector arm.
The ice cubes
The water shuto valve is
are hollow or
not fully open.
small
There is a kink in the water
NOTE: This is
source line.
an indication
of low water
pressure.
A water filter is installed
on the refrigerator.
SOLUTION
Connect refrigerator to
water supply and turn
water shuto valve fully
open.
Turn on the ice maker(s).
See "Controls."
Wait 12 hours after ice
maker installation for ice
production to begin.
Make sure the ice storage
bin is correctly installed.
Allow sufficient time for
ice maker to produce more
ice.
Remove ice from the
ejector arm with a plastic
utensil.
Turn the water shuto
valve fully open.
A kink in the line can
reduce water flow.
Straighten the water
source line.
Remove the water filter
and operate the ice maker.
If ice volume improves,
then the filter may be
clogged or incorrectly
installed. Replace filter or
reinstall it correctly.
Publicité
