Maintenance; Accessories; Technical Specifications - Senco DURASPIN DS230 Mode D'emploi

3. Set the nosepiece on the longest setting possible.
4. Depress the screw selector pin until it is completely depressed. It will be necessary to use a screw or
thin object to depress to this depth.
5. While holding the pin in this position, slide the nosepiece forward and off the slide body.
6. Install the new nosepiece.
7. Replace the nosepiece retention screw ensuring it is seated snug against the slide body.
8. Check for proper fastener length setting (see "Adjusting for Fastener length" above).

Maintenance

Read section titled "Safety Warnings" before maintaining tool.
1. With battery removed or cord disconnected, make daily inspection to ensure free movement of nose-
piece and trigger. Do not use tool if nosepiece or trigger sticks or binds.
2. lubrication of the feed system is not necessary. DO NOT OIl.
3. Wipe tool clean daily and inspect for wear, especially the bit and nosepiece. Replace as necessary.
WARNING
Repairs other than those described here should be performed only by trained, qualified
personnel. Contact SENCO for information at 1-800-543-4596.

Accessories

SENCO offers a full line of DuraSpin screws and accessories for your SENCO tools, including:
• bits
• Storage bag
• Assorted Nosepieces
• Safety Glasses
For more information or a fully illustrated catalogue of Senco accessories, contact your sales
representative or call Senco at 1-800-543-4596

Technical Specifications

SPECIFICATION
WEIGHT
HEIGHT
LENGTH
WIDTH
FASTENER CAPACITY
FASTENER LENGTH
FASTER RANGE
Table 3 - DS230 Tech Specs
DS230-M1/S1
1.3 LBS. (0.579 KG)
5.53" (140.5 MM) MAX
11" (279.5 MM) MAX
2.47" (372.4 MM) MAX
50 SCREWS (1 STRIP)
1-2"
#6-#12
DS230-D1
1.3 LBS. (0.578 KG)
5.53" (140.5 MM) MAX
10.79" (273.98 MM) MAX
2.47" (372.4 MM) MAX
50 SCREWS (1 STRIP)
1-2"
#6-#12
12
DS230-D2
1.3 LBS. (0.580 KG)
5.53" (140.5 MM) MAX
10.34" (262.71 MM) MAX
2.47" (372.4 MM) MAX
50 SCREWS (1 STRIP)
1-2"
#6-#12