Thermador Masterpiece HDDB30WS Instructions D'installation page 19

5. Carefully pull the top part of the extension upwards.
Screw the left and right sides of the extension to the
mounting bracket with the supplied stainless screws.
Installation Instructions
All manuals and user guides at all-guides.com
Recirculating Kit (optional)
When used in recirculation mode, To
Fire and Shock use only conversion k
If it is not possible to vent cooking f
the outside, the hood can be used in
(recirculating) version, using the reci
Fumes and vapors are recycled throu
See optional accessories section.
1 .
4. Measure from the bottom of the air delector to the
Assemble the 3 parts of the delector with 2 - 3.5 x 9.5
The assembled delector should be sized to it the width
C
A
B
Connect the delector to the vent cover bracket using
A
B
A
B
X C
D
E
Remove the air delector.
Slide the duct onto the bottom of the air delector.
Place the assembled air delector and duct over the
Reassemble the air delector to the duct cover bracket
Use duct tape or vent clamps to seal the delector and
RECHDDB.
A. Vent cover bracket width
B. Delector
A. Vent cover bracket
B. 3.5 x 9.5 mm screws
A. Air delector
English | 19 |